1) Matching design of the machine, tank and pipeline should be done by local known design department, and get approval of the police and fire protection department. Don'’t design on yourself to insure the safety.

Diagram 12 is the vertical layout of oil road installation of the machine and mutual system. Installation hints of the machine, pipeline, tank matching design in diagram12 are just for reference .

2) The oil-transporting pipe connecting the machine and the tank should inclines to the tank, the pitch can adopt 1.5%-2.0%.

3) The tank should be buried under ground, setting the tank inside room or basement is forbidden. The thickness of the soil covered on the tank should be no less than 0.5m, which is relative with the allowed suction distance of the machine and the local frozen earth thickness.
The tank should not be buried in the soil with dregs and another caustic chemic matters ,so after installation, around the tank should be filled non- caustic matters, such as clear sand or tiny soil, thickness is no less than 0.3m.

4) Generally speaking, the horizontal distance from the machine to the tank is 20m, sometimes according to different condition, it is also normal if the distance excesses 20m, but the pipeline must not leak air. The vertical distance between the lowest oil surface of the tank and oil inlet of the machine is no more than 4m. The diameter of the pipe connecting the machine and the tank should be 11/2", do not change the diameter on yourself ,pipeline system should take least elbow bends, and inside of the pipe should be cleared off .

5) The joints on the pipe line should be reliable and airproof, if two ends which can be connected with flange should connect with conductive wire. The whole tank and the pipeline system should be under safe grounding condition, and pass the pressure-resistant test, no oil leaking is eligible, before passing the test, do not bury pipeline pit or pour the oil into the tank.

6) The bottom of the oil-inputting pipe inside the tank should equip bottom valve, the axes of bottom valve is lead shape, and the distance to the bottom of the tank is 100mm, after closing the bottom valve, there should be with high airproof performance. The performance of the bottom valve has great effect on the normal usage of the machine, which must be cautiously chosen and installed.

7) Do not use half above the ground, above the ground and high position tank. If the oil inside the tank is higher than oil-gas separator, the exhausting pipe of the separator will overflow the oil, which causes unsafe working condition.

If you cannot but use these tanks, you should pressurizes the exhausting pipe firstly to avoid overflowing oil .

8) Matching the tank with the machine: When one tank supplies the oil to two or more machines, every machine should takes single pipeline, do not parallel connect pipeline at halfway to avoid intervening one another.

If one machine sucks oil from two or more tanks, which should be equipped with necessary valve, when fueling just open the using valve, the others should be closed.Generally, the principle of matching the machine with the tank is that one tank, one bottom valve, one pipe line and one machine, if not the machine will not work normally.